1970 - 1974 Firebird Floor Carpeting with Upgraded MASS BACKING
Made in the U.S.A.
If you want the best carpet available for your 2nd generation Firebird, here it is. This Pre-Molded Carpet Set set is for all 1970, 70, 1971, 71, 1972, 72, 1973, 73, 1974 and 74 Firebird or Trans Am Model. Features the factory correct more full 80 / 20 Loop Material with a ACC Heavy Mass Backing pre-installed. Looks crisp and extra defined once installed. With the Heavy Mass Backing its gives you a much more quiet inside and is easier to install. Exact factory style rubber heel pad, and dimmer switch grommet is included. Strongly recommended for anyone that wants the best for their ride.
*Includes Pre-Installed Jute Padding Like Original!
~~This is a TWO PIECE CARPET WITH A SEAM IN THE CENTER THAT RUNS LEFT to RIGHT!
~~Don't forget to pick your transmission type and desired color choice.
Mass Backing Features:
*Great sound and heat barrier.*Increases the overall look of the carpet after installation.
*Approximately 45 mil thick EVA material.
The Best Carpet Available for your 70-74 Firebird!
*Extra Tail Piece for between the rear seat bottoms is included!
PART NUMBER : INT-1151
- READ FULL INSTRUCTIONS BEFORE BEGINNING *Instructions may vary for multi-piece sets
- 1. Remove new product from box. Lay flat and pop contours back into place. Allow a few hours for product to relax back into proper shape. Check material for accuracy.
- 2. Compare new and old carpet. (New product may have excess material on outer edges.)
- 3. In some applications it may be necessary to use old carpet as a template for console cuts.
- 4. IMPORTANT: Fold new product in half from front to rear. Place in vehicle lining up molded contour to seat risers or any other identifiable starting point on both driver and passenger sides. Once fitted, continue installation.
- 5. Roll product forward making any cuts needed for brackets, shifters and heater vents etc. while maintaining proper alignment on seat risers or other starting point.
- 6. Next, check fit at firewall. May need to cut in center at firewall to allow product to go underneath dash.
- 7. Continue same procedure for remainder of installation – working your way to outer edges.
- 8. Once product is properly fitted you are now ready to do the final trimmings on outer edges, seat belts and holes etc.
- *Note: Applying adhesive to hold product in place is generally not necessary. If desired, only apply a light brush or spray adhesive after correct dry fit has been obtained.
ACC guarantees all of our products to be free from defects in material and workmanship for a period of one year. (Normal wear from use excluded from this guarantee.) ACC will issue a replacement or credit for any defective carpet sets, except those damaged in shipping.
Please contact our Customer Service Department and we will work with ACC to promptly handle your case.
*NOTE: PLEASE INSPECT EACH CARPET SET PRIOR TO INSTALLATION. CARPET SETS CANNOT BE RETURNED AFTER BEING CUT, TRIMMED, GLUED, OR ALTERED IN ANY MANNER.
|
